PrizmDoc Viewer v13.12 Release - Updated
Administrator Guide / Troubleshooting / Check the System's Health
In This Topic
    Check the System's Health
    In This Topic

    Introduction

    While a PrizmDoc Server does its best to keep itself up and running, it is possible for a PrizmDoc Server to become unhealthy, in which case you must restart PrizmDoc Viewer (typically by rebooting the server).

    To check whether or not a server is healthy, simply send an HTTP request GET /PCCIS/V1/Service/Current/Health. If the server is healthy, HTTP 200 will be returned; if unhealthy, HTTP 500 will be returned. Note that if PrizmDoc Viewer has just started, HTTP 500 may be returned for a short time until the system has completely started up.

    Cluster Mode: Use the CEP

    If you are running in cluster mode, send your request to the Cloud Entry Point (CEP), typically running on port 18681:

    Example

    GET server:18681/PCCIS/V1/Service/Current/Health
    
    

    Single-Server Mode: Use the SEP

    If you are running in single-server mode, send your request to the Server Entry Point (SEP), typically running on port 18681:

    Example

    GET server:18681/PCCIS/V1/Service/Current/Health
    
    

    HTTP Response

    • HTTP 200 - Server is healthy and running normally.
    • HTTP 500 - Server is unhealthy and must be restarted (or PrizmDoc Viewer is still starting up).