Prizm Content Connect
ProxyWebService

Prizm Content Connect has a built-in HTTP & HTTPS WebServer that serves the document conversion requests and does load balancing and various other tasks.

By default, after a complete installation, you can check if the HTTP WebServer is running by pointing your browser to:

http://localhost:18680/convert2swf

convert2swf WebService by default is setup to run on port 18680 and in http mode. This host and port can be changed by editing the <prizm-install>\conf\proxyserverjar.properties file.

The parameter values supported by the service are described in ProxyWebService Parameters section.

 

 


©2014. Accusoft Corporation. All Rights Reserved.

Send Feedback